HQ EL-PIRLA80 Specifiche Scaricare il pdf (Pagina 3)

Technical specications

Wattage: 60W/E27

Power supply: 220-240V~, 50/60Hz

Installation sit: indoors, wall/ceiling mounting

HF system: 5.8GHz CW radar, ISM band

Transmission power: <10mW

Detection angle: 360°, 160°

Reach: 1-8m (dia.), adjustable

Time setting: 5sec to 15min

Light control: 2~2000LUX

Power consumption: approx.0.9W

Connection illumination

connect N, L with power;

Reach setting (sensitivity)

Reach is the term used to describe the diameter of the more or less

circular detection zone produced on the ground after mounting the

sensorlight at a height of 2.5m, turn the reach control fully anticlockwise

to select minimum reach (approx.1 m dia), and fully clockwise to select

maximum reach (approx. 8m dia).

Time setting

The light can be set to stay ON for any period of time between approx.

5sec(turn fully anticlockwise) and a maximum of 15min(turn fully

clockwise). Any movement detected before this time elapse will re-start

the timer. It is recommended to select the shortest time for adjusting the

detection zone and for performing the walk test.

NOTE: after the light switches OFF, it takes approx. 1sec before it is able to start

detecting movement again. The light will only switch on in response to movement

once this period has elapsed.

Light-control setting

The chosen light response threshold can be innitely from approx. 2-

2000lux. Turn it fully anti-clockwise to select dusk- to-dawn operation at

about 2 lux. Turn it fully clockwise to select daylight operation at about

2000lux. The knob must be turned fully clockwise when adjusting the

detection zone and performing the walk test in daylight.

SENS TIME LUX

SENS

TIME

LUX

1 2 3 4 5 6 7 8 ... 65 66

Nessun commento

HQ EL-PIRLA80 Specifiche Pagina 3